External Memory Interface Handbook Volume 1: Intel® FPGA Memory Solution Introduction and Design Flow: For UniPHY-based Device Families

Download PDF
ID 710283
Date 3/06/2023
Public
Document Table of Contents
Document Table of Contents x
1. Introduction to this Handbook 2. Recommended Design Flow 3. Selecting Your Memory 4. Selecting Your FPGA Device
1. Introduction to this Handbook x
1.1. Introduction to Memory Solutions 1.2. Protocol Support Matrix 1.3. Document Revision History
2. Recommended Design Flow x
2.1. Getting Started With External Memory Interfaces 2.2. Document Revision History
2.1. Getting Started With External Memory Interfaces x
2.1.1. Selecting Your External Memory Device 2.1.2. Selecting Your FPGA 2.1.3. Planning Your Pin Requirements 2.1.4. Planning Your FPGA Resources 2.1.5. Determining Your Board Layout 2.1.6. Specifying Parameters for Your External Memory Interface 2.1.7. Performing Functional Simulation 2.1.8. Adding Design Constraints 2.1.9. Compiling Your Design and Verifying Timing 2.1.10. Verifying and Debugging External Memory Interface Operation
3. Selecting Your Memory x
3.1. DDR SDRAM Features 3.2. DDR2 SDRAM Features 3.3. DDR3 SDRAM Features 3.4. QDR, QDR II, and QDR II+ SRAM Features 3.5. RLDRAM II and RLDRAM 3 Features 3.6. LPDDR2 Features 3.7. Memory Selection 3.8. Example of High-Speed Memory in Embedded Processor 3.9. Example of High-Speed Memory in Telecom 3.10. Document Revision History
4. Selecting Your FPGA Device x
4.1. Memory Standards 4.2. I/O Interfaces 4.3. Wraparound Interfaces 4.4. Read and Write Leveling 4.5. Dynamic OCT 4.6. Device Settings Selection 4.7. Document Revision History
4.6. Device Settings Selection x
4.6.1. Device Speed Grade 4.6.2. Device Operating Temperature 4.6.3. Device Package Size 4.6.4. Device Density and I/O Pin Counts
1. Introduction to this Handbook
2. Recommended Design Flow
3. Selecting Your Memory
4. Selecting Your FPGA Device

4.4. Read and Write Leveling

The Arria V GZ, Stratix III, Stratix IV, and Stratix V I/O registers include read and write leveling circuitry to enable skew to be removed or applied to the interface on a DQS group basis. There is one leveling circuit located in each I/O subbank.
Note: UniPHY-based designs do not require read leveling circuitry during read leveling operation.

For more information about read and write leveling, refer to Leveling Circuitry section in the Functional Description - UniPHY chapter of the External Memory Interface Handbook.

Related Information
Level Two Title