ALTERA DOES NOT WARRANT THAT THE FUNCTIONS CONTAINED IN THIS PATCH 
WILL MEET YOUR REQUIREMENTS, OR THAT THE OPERATION OF THIS PATCH 
WILL BE UNINTERRUPTED OR ERROR-FREE. 

//**************************************************************** 
quartus-10.0-1.202-readme.txt 
Readme file for Quartus II 10.0 SP1 Patch 1.202
Copyright (C) Altera Corporation 2011 All right reserved. 
Patch created on January 25 2011
Patch SPR#: 365059 
SPRs fixed: 361898
//**************************************************************** 

Problem: There is a bug in physical synthesis that causes functional
	 errors in some rare cases where a design has constant
	 cells. The bug can only happen when physical synthesis is on
	 and the family used is Stratix III, Stratix IV, Arria II GX,
	 HardCopy III or HardCopy IV.


Solution: This patch solves the problem. The patch also provides an
	  INI controlled flow to to identify whether this bug appeared in a
	  compile without the patch. To use this flow, set
	  "fsyn_identify_node_collapse_bug=on" in the quartus.ini file and run
	  Analysis & Synthesis. The compile will fail if an instance of the bug
	  is detected. Make sure the compile is done with the exact same version
	  of Quartus on the same platform, and with the exact same design
	  settings.


Caution - You must either have previously installed the 
          Quartus II 10.0 SP1 software or must 
          install the Quartus II 10.0 SP1 software 
          before installing this patch. Otherwise, the patch will 
          not be installed correctly and the Quartus II 
          software will not run properly.